After you have set up a path with the desired modules you want to use the toggle(image be

low) to enable MicroPaths *NOTE: once this has been changed it can NOT be undone

After you use the toggle you will be given a confirmation,(image below) click on Confirm in red

Screen Shot 2022-05-26 at 1-01-52 PM-png

Depending on how many modules are included in the path will dictate how many micro paths are created

After clicking on Confirm the micro paths will be created (image below), Then by selecting the first micro path will allow you to modify the modules in the first micro path

Screen Shot 2022-05-26 at 1-04-54 PM-png

After selecting the first micro path(red circle in the above image), you can modify the path by dragging and dropping modules below the micro path selection. You can include micro path names and descriptions after you have made the desired modifications you must save the micro path using the bottom right "SAVE MICRO PATH" button (image below).

Screen Shot 2022-05-26 at 1-00-18 PM-png.png

Then you can repeat these steps for modifying each micro path

Did this answer your question?